Test conditions for numerically controlled turning machines and turning centres - Geometric tests for machines with inverted vertical workholding spindles Ingestion-build-276583

Test conditions for numerically controlled turning machines and turning centres - Geometric tests for machines with inverted vertical workholding spindles Ingestion-build-2765831 Scope ISO 13041 3: 2008 specifies, with reference to ISO 230 1 and ISO 230 7, the geometric tests on general purpose, numerically controlled (NC) turning machines and turning centres with inverted vertical workholding spindles, as well as the corresponding applicable tolerances. This part of ISO 13041 presents the different concepts or configurations and common features of NCturning machines and turning centres with inverted vertical spindles. It

It also covers:

titanium and their alloys

This British Standard gives recommendations on the principles which should be observed when designing for the natural ventilation of buildings for human occupation

This standard identifies the main factors that affect the welding of aluminium

trucks and trailers which are used on roads or located on vessels or on rail wagons and/or combinations thereof

Woodland managers and operatives

giving information on the qualification and verification of clean controlled environments

Design requirements verification

these can be made in such a way that they detach or yield under vehicle impact

Water is applied under pressure to the surface of hardened concrete

The plastics / rubber industry

also known as bottom-up or energy performance improvement actions (EPIAs)-based methods (see ISO 17742)