Tools for moulding. Sprue pullers Ingestion-build-105964 additional advice on contingency and

additional advice on contingency and recovery planning

Other(generic) generator types such as ground or surface water or direct use of ground heat from boreholes

Annex B (informative) Error sources

with a capacity up to and including 10 000 kg in accordance with ISO 5053-1 and it is intended be used in conjunction with EN 16842-1

Tools for moulding. Sprue pullers Ingestion-build-105964 additional advice on contingency and1 Scope This International Standard specifies the main dimensions and tolerances, in millimetres, of sprue pullers, which are used mainly in injection moulds for plastics and rubbers. See the example of application in Figure 1. It also specifies the material, hardness and designation of sprue pullers conforming to this International Standard. Figure 1 Application example of sprue pullers 1 ejector pin (ISO 6751) 2 sprue puller (ISO 16915) 3 locating