1-1/2" Tappered Pull Connector Compression Points worn steel bit and cut

worn steel bit and cut off the end so that it will be blunt

The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed

It is designed to absorb lateral forces that the point will experience as it comes in contact with debris from different angles along it's route

It should be 5/8 of an inch long

1-1/2" Tappered Pull Connector Compression Points worn steel bit and cutThis connector is used to connect 1 1 2" poly pipe to the shafts before the shafts are extracted from the ground. This pull connector will make a secure and strong connection to any 1 1 2" rolled Polyethylene conduit for fiber optic Poly pipe for water lines or Polyethylene pipe for gas lines Etc (One size fits all types) It has a swivel between the two ends with lateral wobble. This unique design combination allows for the female threaded end of the