PH 5225 HQ-WB Holden 253-308 Competition Header Type_1500

PH 5225 HQ-WB Holden 253-308 Competition Header Type_1500Product Description Pacemaker Headers to suit Holden HQ HJ HX HZ WB 253 308 V8 Motor Manual & Automatic TUNED design Important Notes Will fit Turbo 400 Will fit with HZ type cable clutch Will not fit HQ type mechanical clutch Will not fit column change automatic or manual Will not fit Powerglide Auto Will fit Ford Toploader gear box with hatfield bell housing Will fit Hydraulic Clutch Conversion Product Specs Part #: PH 5225 P Steering: Yes Gasket:

Subaru Dual Port can only be run in either Dual Port or Plumb back configurations due to design of the factory return hose

WG40 Inlet Weld Flange

high-quality spring clamps to get the job done right

Vacuum Low - 17inHG

Improved boost response

• Will only fit with original engine mounting spacers or PACEMAKER spacers part number Pemp 350 Note: spacers must be fitted on correct side of vehicle

6 Litre petrol V8

or extra assembly are required

5 microns with up to 95% filtration efficiency

it provides easy weldability and long-lasting durability

Base Spring Pressure 7 PSI

These Turbosmart Weld Flanges (Stainless Steel) are designed to perfectly fit Turbosmart’s 38mm UltraGate38 wastegate