Radio Shield RS-UV3

Radio Shield RS-UV3RS UV3 is Obsolete and replaced by the RS UV3A. This page is being left online for legacy users looking for information. Frequency: 144 148, 220 225, 420 450 MHz Sensitivity: 120 dBm for 12 dB SINAD TX Power: 23 dBm + 1dB Spurious Emissions: 60 dB or lower DC input: 9. 5 15V, 100 mA RX, 250 mA TX Size: 4. 7" X 2. 9" Supports ARDUINO, RASPBERRY PI, WINDOWS, LINUX, MAC and others Simple serial interface, no complicated library drivers required Built in

Enhancements of the HARDROCK-50+ over the HARDROCK-50 include:

The kit includes everything that you need:

2A DC output to power QRP transceivers

This kit has everything you need to make a 2-pin power cable to run from your power supply to the HARDROCK-50+

RF frequency detection and COR for automatic band selection with ANY transceiver

the LO signal for the up/down-converter

Keying modes: COR

For more detailed information check out the User Manual in the RS-UV3 Files section of our site

5MM Terminal Blocks

Arduino Nano and the Bluetooth module to the PCB assemble the case

Switch and Cable with header

LCD chip select