High-Pressure Basic Sample Holder - metal contact, 4 mm max. thickness Select wire material::Titanium

High-Pressure Basic Sample Holder - metal contact, 4 mm max. thickness Select wire material::TitaniumThe High Pressure Basic Sample Holder is a high pressure variant of the popular Basic Sample Holder. In this design, a metal wire serves as the electrical conductor between the electrode material, either free standing or deposited on a substrate, and the external circuit. The holder is composed of PEEK body components that are in direct contact with the electrolyte, combined with a stainless steel (316L) fitting that provides mechanical strength where

Color:                             Transparent/ transparent

the complete synthesis of a product through electrochemical processes (small-scale preparative electrosynthesis and electroseparation)

Width:                280 mm

Width:                                     1/2 inch (12

After deposition the coating should be dried in ambient for 24h or cured for 3-10 minutes at 70° - 95°C

DO NOT set the pressure gauge above 90 psi (0

Surface Polishing:          Two sides optical polished

It can provide isostatic hydraulic pressure up to 330 MPa to study SSB properties vs

Microporous Layer

20 mg / cm^2

Autoclavable 2-CEC 50 mL - Autoclavable Two-compartment Electrochemical Cell

Improper grounding may damage the unit