Peugeot 2008 1.6 e-HDi 115 FAP panel filter Suspension

Peugeot 2008 1.6 e-HDi 115 FAP panel filter SuspensionPanel type Unique Panel Dimensions 402mmX171mm

8mm pipework and fit from the catalytic converter section backwards (Cat-back) these parts replace the centre and rear sections

please just advise the colour in the checkout

We also re- locate the air filter (a cone type filter must be used)

Developed and Manufactured

Welded End Tanks compared to weak Ford crimped plastic end tanks that have been proven to leak on  modified cars

takes about 20-30mintutes

The advantages are as follows

6 Ecoboost engine is brought to life with this piece of artwork again crafted by the masters at Milltek Sport

Gauge Mounting Cup is an ideal accessory for the Turbosmart Boost Gauge

as the roll of the chassis is influenced in a positive manner

1 x Forge Sticker

but when we tested the 3” flange up against an OE cat back we found that the flange on the OE cat back is only 78mm tall and with a 76mm hole this would only give 1mm each side for the gasket to seal which is not good enough and will most likely end with a leaking joint