Throttle-by-Wire Extension Harness for Harley-Davidson Reseller Margin

Throttle-by-Wire Extension Harness for Harley-Davidson Reseller MarginOur Throttle by Wire Extension Harness is ideal when adding taller risers and or bars to your Harley Davidson model with throttle by wire. Allows for a clean & simple install. The factory Throttle by Wire for 2016 later models was changed significantly with a much smaller sealed JST Connector. This allows you to change out your bars with one of our sleek plug n play extension harnesses. This harness will run through most aftermarket handlebar

Fits license plate up to 7-1/4" x 4-1/4"

11'') except for Plug-N-Play®

Please note that the bags are not included with the mount

It is a great option for both the single & dual gauge(s) block off setup

It's a simple upgrade that can add a whole lot of cool to your ride

- CV128 fits: 91-05 FXD/FXDWG & 91-02 FLSTF/FXST/FXSTS w/detachable sissy bar

allowing you to upgrade your bike's rear lighting without any hassle

- CV127 fits: 91-05 FXD/FXDWG & 91-02 FLSTF/FXST/FXSTS

Works well with longer 13

it's a neat way to add some extra lights to your ride

It's sized perfectly for 4" x 7" license plates

+ rider and passenger total weight