Top Clamp Set (4pcs) carvera

Top Clamp Set (4pcs) carveraThese are the same as the ones that come with the Carvera machine. The top clamp is typically used to secure workpieces less than 2 cm thick, in conjunction with the thin L Bracket. The cross grooved top clamp is designed to enable the use of longer sides for securing the workpiece. For workpieces thicker than 1 cm, we recommend using shims at the ends of the top clamps.

and detailed surface machining

25 RPM:10000

1 * 3mm x 1

width: 100%

But you can use other models for milling bits with different shanks

the single flute nature of this engraving bit performs well for high chip evacuation and cooling

8mm Corn - - RPM:12000

allowing for deeper cuts to be made

For use of the 3mm spindle collet

Thread Milling Bit - 1/8″ Shank M3(d2

padding: 12px

This enhancement opens up countless DIY design possibilities