Barnett, throttle (pull) cable Black +16

Thoughtful delivery service

Easy 30 day returns

Certified Reviews

Description

Barnett, throttle (pull) cable Black +16"Black; a black vinyl cable with chrome fittings. Used for the stock Keihin CV carburetor and also for the fuel injected models. Outer cable length as mentioned is the over or undersize length of the ''standard'' 32" (81cm) long custom cable length; this is the outer cable length only excluding the elbow. 90 elbow Non threaded circlip design Elbow length: 5" Inner cable sticks out: 4 15 16" Under & oversize lengths are available ranging from 4" under

A black anodized contrast machined (Contrast Cut) finish

The loose fit is relaxed

These Feuling press on races have a precision ground outer diameter finish and are designed to be true to size producing the correct OD after proper press on installation

outer and inner fender and direct-replace them with the Cult-Werk Racing kit

The cap is made from 100% cotton canvas with 100% polyester air-mesh

Set includes: - 30x male terminal pin - 30x female terminal pin - 60x wire seal

TECH TIP: On L84-90 XL Sportster the alternator is installed on the clutch hub

even in direct sunlight

a subtle gloss black and wrinkle black combination finish - CNC machined from hammer forged aluminum to provide maximum structural strength - Complete with pre-installed bearings and spacers for a bolt-in installation - Suitable for tubeless tires - A striking Roland Sands design that is matched only by the detail of its finish - Manufactured by Performance Machine - Will complement all bikes from stock to custom

Black anodized aluminum with a Contrast Cut machined finish

It was used on track days to prevent the headlight glass from shattering all over the circuit when the bike was crashed

Noticeable horsepower and torque gains across the powerband

Exchange/Return Notes